top of page

Power Anodes

 

Protect your tank investment with the new powered anode system for large volume tanks as well as small residential tanks. As a home / building owner or service maintenance provider, the last thing you need is to replace your large volume storage tank because the consumable anodes were not routinely inspected and replaced. Manufacture maintenance procedures are clear, inspect the consumable anodes every 6 months and replace when depleted. Failure to perform the inspection can jeopardize the warranty but more importantly greatly reduce the life expectancy on the tank.  Scheduled maintenance of the tanks anode rods can be a costly process. Not only is there the expense of pulling your system offline, there is considerable down time and disruption of service to the building.  All of this can be eliminated by installing the powered anode system. 

​

Save time, money and know that your tank investment is protected.
The Titanium powered anode and controlled power supply will replace conventional magnesium or aluminum anode rods. The powered anode system monitors the electrical potential of the tank surfaces and supplies identical electrical potential to the anode rod(s). Because there is no difference in electrical potential, corrosion of the tank is prevented and the anodes are not consumed. The system uses low voltage, low current electricity to create electrical potentials inside the tank that prevents corrosion.

 

The titanium anode is non-consumable so it does not need to be replaced and there is no “rotten egg” smell.

hot+water+tank+res.jpg

NACE International specifies - 850 mVolts are required to provide corrosion protection.

​

Powered Anodes which can be programed to 850 mV. 


Lining and anodes will not be required to be replaced.

​

Millivolts

1000     Tank is protected from corrosion. Very hard on the tank lining
900      Tank is protected from corrosion. Hard on the tank lining
850      Ideal protection for tank. Lining inside tank is not required.
800      Tank is protected from corrosion. Lining is required to complete the protection
750      Only the lining is protecting the tank all exposed metals are NOT protected

  • Titanium powered anodes are designed for maintenance free operation.

  • Easy hook-up, plug-n-play. The unit is powered by 120V from a standard wall outlet. The anodes have 1) low voltage wire and a ground wire, which is attached to the tank.

  • The power source is a small 6 1/2″ x 3 1/2″ x 2 1/2″ box that can mount to a wall near the tank. (Within 10′ from the anodes)

  • Visual Alert – If the system detects a fault in the wiring, the power source will ash with a green and red LED.

  • Retrot existing tanks with electric anodes

  • Available for tanks of any size

  • Can be used with ALL TYPES OF LININGS -Cement linings, Epoxy linings, Porcelain Enamel (Glass) linings

 

bottom of page